Skip to main content
Free Shipping on Orders $89.00 or More to the Lower 48 States Same Day Shipping — Order by 3 PM EST M–F … It Ships!

Vacuum and Foam Molding Presses for Thermoform Sheet

Shop molding presses for thermoform sheet, from steel bench and Taco Model foam presses to VacuForge™ vacuum presses used for cosplay, orthotics and small prototyping. The range also covers CKK Series foam in three grades, pre-cut silicone membranes, heat-sink boards and a jig for forming belt loops.

Read more

The VacuForge™ presses mold heated KYDEX®, HOLSTEX®, Boltaron® or ABS by vacuum, sealing a high-heat membrane on a raised edge around the chamber once the magnetic lid is closed. The 12 x 12 press stands on a 15-3/4 inch square footprint and weighs 17 lbs, while the XL gives a 16 x 24 inch work area at 44 lbs. Both connect to your existing vacuum pump through a 1/4 inch intake nipple and carry a 90-day warranty on material and workmanship.

Keeping a VacuForge™ in service means restocking pre-cut 60 durometer silicone membranes in 2-packs and MDF heat-sink boards that work on either side. A replacement gauge, a kit of ten 8-32 lid screws with matching nuts, and elbow and straight fittings for 1/2 inch push-connect hose are stocked too. For a 49 inch wide press or your own, the same silicone comes by the linear foot.

Foam presses squeeze sheet heated to 300 to 375°F between layers of CKK Series foam, graded from Maxx Form through Mega Form to Xtreme Form for rising detail. The steel bench models use 1/4 inch powder-coated plate with a lift-out top plate, and one foam side can be swapped for a hard, flat Micarta® or G10 surface. The Taco Model holds fold-over pieces between its two press wings, much as a book press does, and the Diez Design jig forms belt loops from 12-inch scrap sheet. Our shop staff can talk you through foam versus vacuum forming, and equipment for finishing a formed piece sits under tools.